The traditional square post has been rotated 45° to provide optimized post hole size capacity. The 24mm Rye RDA has a convex deck with a 2 mm gradient – ensuring excess e-liquid is channeled to your wicks and neutralizes unwelcome and avoidable “spit-back”. It also features a highly sophisticated double decker airflow intake system. Both the top cyclops and the lower level circular intake are fully available and adjustable on their own – in addition to being fully opened and closed concurrently. All intake dimensions have been executed with extreme mathematical precision to facilitate optimal performance across the entire spectrum of your preferred airflow control settings. Additionally, with painstaking care, every potential sharp angle with hard cuts has been rounded appropriately to promote airflow which is more fluid. No more hard wall transitions in your RDA’s chamber means less turbulence and a smoother draw. Our proprietary drip tip with it’s 7.25 mm custom bore provides the perfect draw required for the majority of builds which will call this RDA home. An additional drip tip with a 10 mm bore and a 810 to 510 converter is provided should either be required. Extra O-rings, screws, a squonk pin, and a genuine anti-strip hex tool comes standard with every RDA that leaves our doors.
This product is for advanced vapers only and requires technical knowledge in order to use it. Please read the disclaimer below before purchasing this product. DO NOT purchase if you are not comfortable or experienced with these types of atomisers.
Note: A rebuildable coil/wick MUST be tested carefully with an ohm meter before use. If your builds are not tested prior to use, it is entirely at your own risk. Faulty wicks/coils WILL damage electronic devices. New coil/wick units must be tested and then used first on a strong basic electrical APV that has short circuit protections. No new coil/wick assembly should NOT be used on an electronic device until known it is safe to do so.
Disclaimer: Rebuildable atomizers are for advanced vapers only with access to multimeters, high discharge batteries and a working knowledge of how electronic devices work. Please ensure care is taken as to not cause damage/harm to your atomizer, vaping devices, or yourself. Upon purchasing this product you agree that Custom Vapes UK, will not be held responsible to any injuries or property damage caused by using/misusing this product.
Warranty: Low Resistance Atomizers, Clearomizers, Cartomizers, RDA, RBA may not be returned if they have been filled/built/used unless the product was defected upon receipt and we are notified within 48hrs. We strongly recommend the use of an ohm meter to check resistance for possible shorts. Due to hygiene reasons and the nature of low resistance sub ohm builds, the use of third party units/mods or non approved chargers, no returns are accepted on any atomizers and Li-Ion batteries unless the product was defective upon receipt or dead on arrival (DOA) and we are notified within 48hrs. For more information please refer to our returns policy.