OVER A DECADE OF SERVICE (EST. 2013)

Dotshell By Atimizoo

£ 74.99£ 79.99

0 review  |  Write a review

Dotshell By Atimizoo is a dedicated RBA for the dotAIO by Dotmod. Based on the VapeShell, yet taking quite some steps forward, the DotShell introduces all features of RBAs to the world of AIO devices. The DotShell utilises the top part of dotAIO’s stock reservoir and incorporates an adaptation of dotAIO RBA’s AFC system, with real time access to further customise the air flow under the coil.

The optional purchase of the MTL Air Flow Pin Kit allows a true MTL experience with no need of AFC Ring adjustment.

Features:
• Air Flow Tuning Via AFC Ring + Pos. Tube
• Spare Pos. Tube Airflow 0-2mm Dia
• Stock Pos. Tube Airflow 0-3.8mm Dia
• 4.2mm Maximum Coil Height In Chamber
• 2.5mm Pan Head Phillips Post Screws
• SS316F & PEEK Insulators

Earn up to 400 points.
Clear

Contents:
1 x DotShell RBA + Reservoir Top
1 x Stock dotAIO 510 Rebuild Base
1 x Pos. Tube Hole Dia 2mm, 2 x Spare Post Screws, 1 x O-ring Kit
1 x User Manual, 1 x Warranty Card

This product is for advanced vapers only and requires technical knowledge in order to use it. Please read the disclaimer below before purchasing this product. DO NOT purchase if you are not comfortable or experienced with these types of atomisers.

Note: rebuildable coil/wick MUST be tested carefully with an ohm meter before use. If your builds are not tested prior to use, it is entirely at your own risk. Faulty wicks/coils WILL damage electronic devices. New coil/wick units must be tested and then used first on a strong basic electrical APV that has short circuit protections. No new coil/wick assembly should NOT be used on an electronic device until known it is safe to do so.

Disclaimer: Rebuildable atomizers are for advanced vapers only with access to multimeters, high discharge batteries and a working knowledge of how electronic devices work. Please ensure care is taken as to not cause damage/harm to your atomizer, vaping devices, or yourself. Upon purchasing this product you agree that Custom Vapes UK, will not be held responsible to any injuries or property damage caused by using/misusing this product.

Warranty: Low Resistance Atomizers, Clearomizers, Cartomizers, RDA, RBA may not be returned if they have been filled/built/used unless the product was defected upon receipt and we are notified within 48hrs. We strongly recommend the use of an ohm meter to check resistance for possible shorts. Due to hygiene reasons and the nature of low resistance sub ohm builds, the use of third party units/mods or non approved chargers, no returns are accepted on any atomizers and Li-Ion batteries unless the product was defective upon receipt or dead on arrival (DOA) and we are notified within 48hrs. For more information please refer to our returns policy.

Weight 100 g
Colour

, , ,

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…

  • The MTL Air Flow Pin Kit reduces the positive tube’s initial 4mm hole diameter down to 1mm, 1.2mm and 1.5mm respectively, offering the ideal air flow for a substantial range of MTL vaping profiles.

    Features:
    • Compatible With DotShell & VapeShell
    • Laser Engraved Hole Diameter On Pins
    • 1mm Hole Diameter Air Flow Tuning Pin
    • 1.2mm Hole Diameter Air Flow Tuning Pin
    • 1.5mm Hole Diameter Air Flow Tuning Pin

     

    £ 10.99
    Purchase & earn 55 points!Read more
×
×
×
×